Door lock - removal and refitting

Bodywork and fittings / Door lock - removal and refitting

Removal
1 It is not necessary to remove the trim panel to carry out this task.

2 Open the door and set the lock in the locked position, either by moving the interior knob or by turning the exterior key.

3 Using an Allen key, unscrew the retaining screws and withdraw the lock approximately 12 mm to expose the operating lever (see illustration) .

18.3 Door lock

4 Retain the operating lever in the extended position by inserting a screwdriver through the hole in the bottom of the lock (see illustration).

18.4 Using a screwdriver through the door lock hole (E) to retain operating lever (A) in extended position

5 Unhook the remote control rod from the operating lever and pull the upper lever from the sleeve. Withdraw the lock from the door.

Refitting
6 Refitting is a reversal of removal. Set the lock in the locked position first and ensure that the lugs on the plastic sleeve are correctly seated.