Volkswagen Golf/Jetta 2 manual

Window regulator - removal and refitting
Bodywork and fittings / Window regulator - removal and refitting


Manual
1 Remove the door trim panel.

2 Temporarily refit the window regulator handle and lower the window until the lifting plate is visible.

3 Remove the bolts securing the regulator to the door and the bolts securing the lifting plate to the window channel (see illustrations).

20.3a Window regulator securing bolts
20.3a Window regulator securing bolts

20.3b Lifting plate-to-window channel bolts
20.3b Lifting plate-to-window channel bolts

4 Release the regulator from the door and remove it through the aperture.

5 Refitting is a reversal of removal. Ensure that the inner cable is adequately lubricated with grease and if necessary, adjust the position of the regulator so that the window moves smoothly.

Electric
6 Disconnect the battery earth lead.

7 Remove the door trim panel.

8 Lower the window to enable the bolts securing the lifting plate to the window channel to be unscrewed.

9 Disconnect the wiring connector.

10 Unscrew and remove the window regulator motor securing bolts and the three bolts securing the guide rail (see illustration).

20.10 Window regulator (electric)
20.10 Window regulator (electric)

1 Wiring connector
2 Motor securing bolts
3 Guide rail bolts

11 Withdraw the window regulator assembly (ie. the motor, cables and guide rails) from the aperture at the bottom end of the door.

12 Refit in the reverse order of removal.

Ensure that the upper cable is located underneath the guide rail securing bracket and, when refitting the door trim panel, the plastic cover is crease free.


© 2018 www.vwgolfjetta2.ru. All Rights Reserved.