Volkswagen Golf/Jetta 2 manual

Combination switches - removal and refitting
Body electrical systems / Combination switches - removal and refitting


1 Remove the steering wheel.

2 Disconnect the battery negative lead.

3 Remove the screws and withdraw the steering column lower shroud.

4 Remove the three screws securing the combination switch (see illustration).

12.4 Combination switch retaining screws (arrowed)
12.4 Combination switch retaining screws (arrowed)

5 Disconnect the multi-plugs (see illustration).

12.5 Combination switch multi-plug connections
12.5 Combination switch multi-plug connections

6 Rotate the indicator switch clockwise and withdraw it, noting location of the plastic retaining arms (see illustration).

12.6 Removing indicator switch . . .
12.6 Removing indicator switch . . .

7 Withdraw the wiper control switch from the column. Full removal of the switch of GTi models will necessitate detaching the additional wire from its connector under the dash panel (see illustrations).

12.7a . . . and wiper control switch
12.7a . . . and wiper control switch

12.7b Additional under dash wiring connection and insulator Ц GTi
12.7b Additional under dash wiring connection and insulator Ц GTi

8 Refitting is a reversal of the removal procedure. Check that the indicator switch is centralised before fitting the steering wheel otherwise the cancelling cams could be damaged.

9 Refit the steering wheel.

10 On completion, check the operation of the switches.


© 2018 www.vwgolfjetta2.ru. All Rights Reserved.