Volkswagen Golf/Jetta 2 manual

Facia trim panel - removal and refitting
Body electrical systems / Facia trim panel - removal and refitting


1 Disconnect the battery earth lead.

2 To improve accessibility, remove the steering wheel.

3 Remove the radio.

4 Pull free the heater/fresh air control lever knobs, then release the control panel retaining clips around the outer edge and pull out the panel. Detach the wiring multi-connectors.

5 Remove the lower switches from the facia panel and where applicable, remove the blank pads by prising them free.

6 Unscrew the facia trim panel retaining screws from the following locations: a) Light switch aperture b) Top inner edge of radio aperture c) Fader control (or blank) aperture (see illustration)

18.6a Facia trim panel retaining screw through fader control aperture
18.6a Facia trim panel retaining screw through fader control aperture

d) Heater control panel aperture e) Top of the instrument panel (see illustration)

18.6b Remove instrument panel retaining screws at top
18.6b Remove instrument panel retaining screws at top

f) Top left side of panel 7 Partially withdraw the panel and detach any remaining switch lead multi-connectors.

Remove the facia panel (see illustration).

18.7 Facia trim panel removal
18.7 Facia trim panel removal

8 Refit in the reverse order of removal, ensuring that all wiring connections are securely made.

9 On completion, check for correct operation of the various switches and controls.


© 2018 www.vwgolfjetta2.ru. All Rights Reserved.