Volkswagen Golf/Jetta 2 manual

Rear window wiper motor - removal and refitting
Body electrical systems / Rear window wiper motor - removal and refitting


1 Disconnect the battery negative lead.

2 Open the tailgate and prise off the inner trim panel.

3 Remove the wiper arm and unscrew the outer nut. Remove the spacers.

4 Undo the bearing retaining bolts and the motor mounting bolts. Withdraw the motor and disconnect the wiring plug (see illustrations).

28.4a Rear wiper bearing mounting and connecting rod
28.4a Rear wiper bearing mounting and connecting rod

28.4b Rear wiper motor mounting in tailgate
28.4b Rear wiper motor mounting in tailgate

5 If detaching the crank and connecting rod from the wiper motor pivot, mark a corresponding alignment position across the crank arm and pivot end face. Undo the nut to detach the crank arm.

6 The wiper motor is secured to the mounting by three bolts.

7 Refitting is a reversal of the removal procedure. Correctly align the crank arm when refitting so that the wiper arm will park correctly (see illustration).

28.7 Rear wiper motor bellcrank angle
28.7 Rear wiper motor bellcrank angle


© 2018 www.vwgolfjetta2.ru. All Rights Reserved.